Measuring the distance using HC SR-04 and Display the Data on LCD interfacing with Arduino uno - KT930

• Arduino uno with USB Cable – 1
• Jumper wire male to male – 40 pieces
• Jumper wires Male to Female – 10 pieces
• Breadboard 830 points – 1
• 10k Potentiometer – 1
• 16*2 LCD Display – 1
• HC Sr-04 Ultrasonic sensor- 1
• Single Stand wire 1mt -1

• Arduino uno with USB Cable – 1
• Jumper wire male to male – 40 pieces
• Jumper wires Male to Female – 10 pieces
• Breadboard 830 points – 1
• 10k Potentiometer – 1
• 16*2 LCD Display – 1
• HC Sr-04 Ultrasonic sensor- 1
• Single Stand wire 1mt -1

Arduino IDE 1.8.5 (Programmable Platform for Arduino Boards)
Click to download the software: https://camblick.com/en/Main/Software

HC SR04 ULTRASONIC SENSOR

16*2 LCD DISPLAY

10K POTENTIOMETER

Connection for LCD 16*2 Display with Arduino uno

Connection for HC SR-04 Ultrasonic Sensor with Arduino UNO

Connection for the potentiometer with LCD 16*2 and Breadboard

Before coding, you have to install new ping library

https://camblick.com/open?id=11gy_6v61-Eq0sAz8RJF_sn5Tl0g7z8Cj

Sketch > Include library > Manage Library > Search NEWPING library > download it

Or you download NewPing Library from other site.

https://camblick.com/open?id=107vaWoBXZ8t6xtLExf7GQPetTcTP6glO

After compiling, uploading and running it

As far as the object goes far from the ultra-sonic sensor, Distance will be vary and measured distance will be show in LCD

in the Serial Monitor (Tools -> Serial Monitor or Ctrl + Shift + M) the sensor was sending correct data

Note: Must Set the baud Rate to 115200

Ping: 36 cm or the value shown in the serial monitor depends on the object distance from the ultra-sonic sensor.